Huawei HG8145V5

# Huawei HG8145V5 WiFi Setup Guide

Step 1: Connect to the Device

1. Connect your computer to the Huawei HG8145V5 using an Ethernet cable or connect to its default WiFi network if available.

Step 2: Access the Admin Panel

1. Open a web browser.

1. Enter the default IP address: [192.168.100.1](file:///ips/192-168-100-1) (which is the standard gateway for Huawei ONTs).

1. Log in using the default credentials.

HG8145V5 Default Credentials

To modify settings, you need the administrator login. Here is the credential matrix:

| Username | Password | ISP / Region Access Level |
| --- | --- | --- |
| telecomadmin | admintelecom | Global Full Administrator |
| root | admin | Standard User / Read-Only |
| admin | admin | Standard User (secondary) |
| *Custom* | *Serial Number* | Custom ISP provisioned logins |

For full wireless control and WAN setups, log in using telecomadmin. Standard logins may block access to VLAN and WAN configurations.

Step 3: Configure Wireless Settings

1. Navigate to WLAN -> WLAN Configuration in the top menu.

1. Enable the Wireless option for 2.4GHz and 5GHz.

1. Configure the following settings:

- SSID Name: Enter your desired WiFi network name.
- Security Mode: Set to WPA2-PSK or WPA2/WPA3-PSK hybrid.
- Pre-Shared Key: Enter your secure WiFi password.

1. Click Apply to save the changes. If you need to change your login credentials, visit the [router-password](file:///router-password) settings.

Common ISP Configurations

Huawei HG8145V5 is a GPON Optical Network Terminal (ONT). Standard fiber setup details:

GPON Authentication: Auths via LOID (Logical ONT Identifier) or SN (Serial Number) supplied by your fiber provider.

PPPoE WAN Interface: Under WAN configuration, select PPPoE WAN type, enter your ISP username/password, and bind it to the relevant VLAN ID.

VLAN Tagging: Most fiber providers require tagging (e.g., VLAN ID 10 or 20) for internet traffic.

IPTV Configuration: Set up a secondary WAN interface in bridge mode tagged with the IPTV VLAN ID and bind it to a specific LAN port.

Troubleshooting HG8145V5

LOS Light Blinking Red: Loss of Optical Signal. Inspect the fiber optic cable for sharp bends or breaks. Contact your ISP if line levels fall below -27 dBm.

PON Light Blinking Green: The ONT is trying to authenticate with the OLT at the central office. Wait for it to turn solid green.

Internet Not Working: Ensure the WAN interface displays a valid IP. If connection parameters are lost, you might need to perform a [router-reset](file:///router-reset).

WiFi Not Broadcasting: Ensure WLAN is active in the interface and the physical Wi-Fi button on the ONT side panel is not toggled off.